|
During system POST, the audible alarm on the controller will produce one of a number of beep sequences to indicate the status of the controller.
Below is a description of these beep sequences:
Beep Sequences
| Beep Sequence |
Status |
| beep - pause - beep, beep, beep |
Controller startup was successful. |
| beep, beep, beep, beep, ... |
RAID controller has a problem. A possible cause is disk failure. To diagnose the problem, run the Storage Console to check the status of the RAID controller and array. |
beep, beep -
pause - beep,
beep - pause - ... |
Memory or firmware may have a problem. More details may be available from the boot message. If necessary, recover the firmware. | |
This applies to:
| 
