The front panel audio header (J8B4) on the Intel® Desktop Boards listed below has a jumper connecting pins 5 and 6 and another connecting pins 9 and 10. This connection is used to route the audio to either the front or the back panel.
Caution: Do not place the jumpers on this block in any configuration other than the one described below. Other configurations are not supported and may damage the desktop board.
Note: To route the audio to the front panel, remove the shunts as shown on the right and place the connecting cable from your front panel audio solution on the header.
Caution: If you remove the shunts, shown at left above, and do not place the cable from your front panel audio solution on the header, you will not have any audio or microphone signals present on either the front or the back panel audio connections.
For more information regarding audio solutions for Intel Desktop Board D845HV, please refer to the Technical Product Specification (TPS).
This applies to: