|
End of Interactive Support
Intel is announcing the end of interactive support for the Intel® NX440LX Motherboard. See the End of Interactive Support Announcement for details.
Latest BIOS and drivers
Refer to the current drivers and BIOS version for the Intel® NX440LX motherboard.
Processors Supported
The Intel® NX440LX Motherboard supports Pentium® II processors at 233, 266, 300 or 333 MHz. Also see the additional information on processors supported and special information for using 333 MHz Pentium II processors.
Configuration Jumper and Options
A single jumper enables
the Intel® NX440LX Motherboard's configuration mode. All options are then
available through the BIOS Setup screens, which are documented in
the Technical Product Specification.
Synchronous DRAM (SDRAM) DIMMs
Only Synchronous DRAM (SDRAM) DIMMs are supported on the Intel® NX440LX Motherboard. The memory should meet version 1.0 of the 4-clock, 3.3 volt SDRAM specification and must have the Serial Presence Detect (SPD) EPROM programmed.
Will my ATA-66 Hard Drive Work on the Intel NX440LX Motherboard?
The IDE controller
integrated into the Intel® NX440LX Motherboard supports Ultra DMA modes 0,1
and 2. Ultra DMA mode 2, also known as ATA-33 or Ultra DMA 33, is
the highest speed transfer mode supported by the Intel NX440LX Motherboard. The
motherboard hardware cannot support the maximum transfer rate of the
ATA-66 drives. A drive that complies with the ATA-66 specification
will run timings up to Ultra ATA-33 on the Intel NX440LX
Motherboard. Please refer to the Technical Product Specification and the
Motherboard Specification Update for more complete details on the various transfer modes.
This applies to:
| 
