• System memory features
• Supported memory configurations
• Tested memory

System memory features

The board has six DIMM sockets and supports the following memory features:

• 1.5 V, 1.3 V, and 1.25 V DDR3 SDRAM DIMMs
• Three independent memory channels with interleaved mode support
• Unbuffered, single-sided or double-sided DIMMs with the following restriction: Double-sided DIMMs with x16 organization are not supported
• 24 GB maximum total system memory
• Minimum total system memory: 1 GB
• ECC and non-ECC DIMMs
• Serial Presence Detect
• DDR3 2400 MHz, 2133 MHz, 1866 MHz, 1600 MHz, 1333 MHz, and 1066 MHz SDRAM DIMMs
• XMP version 1.2 performance profile support for memory speeds above 1600 MHz

To be fully compliant with all applicable Intel® SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your memory modules do not support SPD, you will see a notification to this effect on the screen at power up. The BIOS will attempt to configure the memory controller for normal operation.

Using a DIMM with a voltage rating higher than 1.65 V may damage the processor.

32-bit operating systems are limited to a maximum of 4 GB of memory. The operating system report less than 4 GB because of the memory used by add-in graphics cards.

Supported memory configurations

Tested memory

Computer Memory Test Labs* (CMTL) tests third-party memory for compatibility with Intel boards as requested by memory manufacturers. See the CMTL tested memory list for this Intel® Desktop Board.

The table below lists parts which passed testing during development. These part numbers may not be readily available throughout the product life cycle.

This applies to:

Intel® Desktop Board DX58OG