System Memory Features
The board has two DIMM sockets and support the following memory features:

• 2.5 V (only) DDR SDRAM DIMMs with gold-plated contacts
• Unbuffered, single-sided or double-sided DIMMs with the following restriction: Double-sided DIMMs with x16 organization are not supported.
• 2 GB maximum total system memory
• Minimum total system memory: 128 MB
• Non-ECC DIMMs
• Serial Presence Detect
• DDR 400 MHz and DDR 333 MHz SDRAM DIMMs

Note:
To be fully compliant with all applicable DDR SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. This allows the BIOS to read the SPD data and program the chipset to accurately configure memory settings for optimum performance. If non-SPD memory is installed, the BIOS will attempt to correctly configure the memory settings, but performance and reliability may be impacted or the DIMMs may not function under the determined frequency.


Supported system bus frequency and memory speed combinations

Supported DIMM Configurations

Tested Memory

Vendor Self Tested Memory
Intel supplies the memory vendors that participate in this program with a common memory test plan to use as a basic checkout of the memory stability. Memory listed here was either tested by the memory vendor or by Intel using this test plan. These part numbers may not be readily available throughout the product life cycle.

The table below lists parts which passed testing conducted using Intel's Self Test program for Intel® Desktop Board D915PDT.

Updated: December 4, 2006

This applies to:

Intel® Desktop Board D915PDT