|
The Intel® Desktop Board D850GB supports ACPI S3. To enable S3, do the following:
- Ensure that your D850GB has BIOS P05 or later.
- Boot-up the computer and press "F2" to run Setup.
- Press "F9" to Load Default Values.
- Go to "Advanced", "Boot Configuration", and select "Yes" to "Reset Config Data".
- Go to "Power", then "ACPI" and select "S3 State" for "ACPI Suspend State".
- Press "F10" to Save and Exit.
- Install an ACPI compliant Operating System (O/S) like Windows* Millennium, Windows* 2000, or Windows* 98SE.
- Install the latest INF Update Utility (PC99 Certified) for the Intel® 850 chipset.
- If you plan to take advantage of the new SSE2 instructions for the Intel® Pentium® 4 Processor, you MUST install Microsoft DirectX* 8.0*.
- Verify that the O/S (for example, Windows Millennium) has properly detected your monitor. (If not, search for a Windows Millennium driver for your monitor).
- Update the video adapter driver with the latest video driver.
- Go to Control Panel, select Power Options, and then select Advanced. In Advanced, for the option "When I press the power button on my computer", select "Stand By".
| Note |
ACPI S3 State is only supported in the following O/S's: Windows* Millennium, Windows* 2000, and Windows* 98SE. | |
This applies to:
| 
