Desktop Boards
Intel® Desktop Board D845GLLY
System memory

Memory testing has been performed under the following category:

Advanced Tested Memory*
Intel provides the Advanced environmental test procedures, test software and necessary hardware to an independent test lab to perform Advanced testing as requested by the memory vendors.
Memory tested by Computer Memory Test Labs (CMTL)*.

Intel Internal Tested Memory
Intel's has a limited amount of memory tested for the desktop board. These part numbers may not be readily available throughout the product life cycle.


System Memory Features

The D845GLLY board provide the following memory features:

  • Two DIMM sockets supporting 3.3 V (only) 168-pin 133 MHz Single Data Rate (SDR) SDRAM DIMMs with gold-plated contacts
  • Unbuffered non-ECC DIMMs only
  • Maximum total system memory: 2 GB; minimum total system memory: 64 MB
  • Serial Presence Detect (SPD) DIMMs only
  • Suspend to RAM
Caution Do not use ECC DIMMs with the Desktop Board. Using ECC DIMMs could damage the Desktop Board.

Integrator's Notes:

  • Registered DIMMs are not supported on the Desktop Board.
  • This Desktop Board has been designed to support DIMMs based on 512 Mbit technology for a maximum onboard capacity of up to 2 GB, but this technology has not been validated on this board.

Note To be fully compliant with all applicable PCI33 SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. This allows the BIOS to read the SPD data and program the chipset to accurately configure memory settings for optimum performance.

The following table lists the supported SDR DIMM configurations.

DIMM Capacity Configuration SDR SDRAM Density SDR SDRAM Organization Front-side/Back-side Number of SDR SDRAM Devices
32 MB SS 64 Mbit 4 M x 16/empty 4
64 MB DS 64 Mbit 4 M x 16/4 M x 16 8
64 MB SS 64 Mbit 8 M x 8/empty 8
64 MB SS 128 Mbit 8 M x 16/empty 4
128 MB DS 64 Mbit 8 M x 8/8 M x 8 16
128 MB DS 128 Mbit 8 M x 16/8 M x 16 8
128 MB SS 128 Mbit 16 M x 8/empty 8
128 MB SS 256 Mbit 16 M x 16/empty 4
256 MB DS 128 Mbit 16 M x 8/16 M x 8 16
256 MB DS 256 Mbit 16 M x 16/16 M x 16 8
256 MB SS 256 Mbit 32 M x 8/empty 8
512 MB DS 256 Mbit 32 M x 8/32 M x 8 16
Note In this column, "DS" refers to double-sided memory modules (containing SDR SDRAM devices on both sides) and "SS" refers to single-sided memory modules (containing SDR SDRAM devices on only one side).

This applies to:
Intel® Desktop Board D845GLLY



Solution ID: CS-012825
Date Created: 30-Jun-2004
Last Modified: 30-Jul-2010
Back to Top