|
|
|
 |
 |
|
| Intel® Desktop Board D845GLAD |
|
 |
|
|
Contents
Jumper Location
Caution: Do not move any jumpers with the power on. Always turn off the power and unplug the power cord from the computer before changing a jumper setting. Otherwise, the Desktop Board could be damaged.
The figure below shows the location of the jumper blocks.
![[D845GLAD Desktop Board Jumper Diagram]](/support/motherboards/desktop/d845glad/img/ad_jump.gif)
The 3-pin jumper block determines the BIOS Setup program's mode. The table below describes the jumper settings for the three modes: normal, configure, and recovery. When the jumper is set to configuration mode and the computer is powered-up, the BIOS compares the processor version and the microcode version in the BIOS and reports if the two match.
BIOS Setup Configuration Jumper Settings
| Function/Mode | Jumper Setting | Configuration | | Normal | 1-2 | The BIOS uses current configuration information and passwords for booting. | | Configure | 2-3 | After the POST runs, Setup runs automatically. The maintenance menu is displayed. | | Recovery | None | The BIOS attempts to recover the BIOS configuration. A recovery diskette is required. |
|
Updated: Monday, May 20, 2002
This applies to:
|
|
|
|
End of Interactive Support DisclaimerIntel no longer provides email, chat, or phone support for this discontinued product(s). Product support information on the Intel web site is provided for reference and subject to the " Terms of use".
Intel will not provide future software updates to support new operating systems or improve compatibility with third-party devices and software products.
|
|
Solution ID: CS-008715
Date Created: 25-Jan-2004
Last Modified: 16-Nov-2009
|
|
