|
|
|
 |
 |
|
| Intel® Desktop Board D845BG |
|
 |
|
|
Contents Jumper Location
Caution: Do not move any jumpers with the power on. Always turn off the power and unplug the power cord from the computer before changing a jumper setting. Otherwise, the board could be damaged.
The figure below shows the location of the jumper blocks.
| Item | Description | Reference Designator | | A | Front panel audio connector/jumper block | J6B1 | | B | BIOS Setup configuration jumper block | J6H2 |
|
Front Panel Audio Connector/Jumper Block
This connector has two functions: - With jumpers installed, the audio line out signals are routed to the back panel audio line out connector.
- With jumpers removed, the connector provides audio line out and mic in signals for front panel audio connectors.
The table below describes the two configurations of this connector/jumper block.
Caution: Do not place jumpers on this block in any configuration other than the one described in the table below. Other jumper configurations are not supported and could damage the board.
Front Panel Audio Connector/Jumper Block
| Jumper Setting | Configuration | 5 and 6
9 and 10 | Audio line out signals are routed to the back panel audio line out connector. | | No jumpers installed | Audio line out and mic in signals are available for front panel audio connectors. |
|
Note: When the jumpers are removed and this connector is used for front panel audio, the back panel audio line out and mic in connectors are disabled.
BIOS Setup Configuration Jumper Settings
The 3-pin jumper block determines the BIOS Setup program's mode. The table below describes the jumper settings for the three modes: normal, configure, and recovery. When the jumper is set to configuration mode and the computer is powered-up, the BIOS compares the processor version and the microcode version in the BIOS and reports if the two match.
BIOS Setup Configuration Jumper Settings
| Function/Mode | Jumper Setting | Configuration | | Normal | 1-2 | The BIOS uses current configuration information and passwords for booting. | | Configure | 2-3 | After the POST runs, Setup runs automatically. The Maintenance menu is displayed. | | Recovery | None | The BIOS attempts to recover the BIOS configuration. A recovery diskette is required. |
|
This applies to:
|
|
|
|
End of Interactive Support DisclaimerThese products are no longer being manufactured by Intel. Additionally, Intel no longer provides interactive support for these products via telephone or e-mail, nor will Intel provide any future software updates to support new operating systems or improve compatibility with third party devices and software products.
THESE DOCUMENTS ARE PROVIDED FOR HISTORICAL REFERENCE PURPOSES ONLY AND ARE SUBJECT TO THE TERMS SET FORTH IN THE "Terms of use". For information on currently available Intel products, please see www.intel.com/products.
|
|
Solution ID: CS-013121
Date Created: 12-Jul-2004
Last Modified: 09-Jun-2006
|
|
