|
End of Interactive Support
Intel is announcing the end of interactive support for the Intel® Desktop Board D815BN. See the End of Interactive Support Announcement for details.
Contents
Advanced Tested Memory
The table below lists parts which passed Advanced testing conducted by Computer Memory Test Labs (CMTL
†) for the Intel® Desktop Board D815BN.
PC133 DIMMs
| Size (MB) |
Manufacturer* |
Manufacturer Part Number |
ECC or non-ECC |
| 64 |
Dane-Elec Manufacturing |
DP133-064083A |
non-ECC |
| 64 |
GoldenRAM |
7550310-GR |
non-ECC |
| 64 |
GoldenRAM |
7550410-GR |
ECC |
| 128 |
Aved Memory Products |
AMP366P1723ATE-C75/H |
non-ECC |
| 128 |
Dane-Elec Manufacturing |
DP133-064163A |
non-ECC |
| 128 |
Dane-Elec Manufacturing |
DP133-072163A |
ECC |
| 128 |
Dataram |
DTM60143(60143Z)(M) |
non-ECC |
| 128 |
GoldenRAM |
7550420-GR |
ECC |
| 128 |
PNY |
6416ZHSEM4G09TWN-PH0 |
non-ECC |
| 128 |
PNY |
6416ZHSEM4G09TWN-PK0 |
non-ECC |
| 256 |
Aved Memory Products |
AMP366P3323ATE-C75/H |
non-ECC |
| 256 |
Dane-Elec Manufacturing |
DP133-064323E |
non-ECC |
| 256 |
GoldenRAM |
7550330-GR |
ECC |
| 256 |
GoldenRAM |
7550430-GR |
ECC |
| 256 |
PNY |
6432ZHSEM4G17TWN-PH0 |
non-ECC |
| 256 |
PNY |
6432ZHSEM4G17TWN-PK0 |
non-ECC |
| 512 |
Aved Memory Products |
AMP366P6453BT1-C75/S |
non-ECC |
| 512 |
GoldenRAM |
7550340-GR |
ECC |
| 512 |
GoldenRAM |
7550440-GR |
ECC |
| 512 |
Viking |
INT51207 |
non-ECC | |
Tested Memory
Memory testing has been performed by the following:
- Advanced Tested Memory
Intel provides environmental test procedures, test software and production level desktop motherboards to an independent test lab to perform Advanced testing as requested by the memory vendors.
- Memory tested by Computer Memory Test Labs (CMTL).
[view] Advanced Tested Memory tables
- Self Tested Memory
Intel provides Basic test procedures and test software to memory manufacturers to perform Basic testing on their own products. These products are then listed on their own website. Please visit their sites to obtain information on their products.
The list below contains vendors that have tested their memory for desktop boards D815BN, and that have their products listed on their own website. Please visit their sites to obtain information on their products.
*Note: These sites will take you off of the Intel website. Intel is not responsible for the content on these sites.
System Memory Combinations
The desktop board has three DIMM sockets and supports the following memory features:
- 3.3 V (only)168-pin SDRAM DIMMs with gold-plated contacts
- Unbuffered Single- or double-sided DIMMs
- Maximum system memory: 512 MB; minimum system memory; 32 MB
- 133 MHz SDRAM or 100 MHz SDRAM
- Serial Presence Detect (SPD) and non-SPD memory
- Non-ECC and ECC DIMMs (ECC DIMMs will operate in non-ECC mode only)
- Suspend to RAM
When installing memory, note the following:
- Non-SPD DIMMs will always revert to a 100 MHz SDRAM bus with 3-3-3 timing.
- Mixing non-SPD DIMMs with SPD DIMMs will always revert to a 100 MHz SDRAM bus with 3-3-3 timing.
- The BIOS will not initialize installed memory above 512 MB. At boot, the BIOS displays a message indicating that any installed memory above 512 MB has not been initialized.
- Mixed memory speed configurations (133 and 100 MHz) will default to 100 MHz.
- 133 MHz SDRAM operation requires a 133 MHz system bus frequency processor.
- The board should be populated with no more than four rows of 133 MHz SDRAM (two double-sided or one double-sided plus two single-sided DIMMs).
- 100 MHz SDRAM may be populated with six rows of SDRAM (three double-sided DIMMs).
NOTE: If more than four rows of 133 MHz SDRAM are populated, the BIOS will initialize installed memory up to 512 MB at 100 MHz.
† This link will take you off of the Intel Web site. Intel does not control the content of the destination Web Site.
This applies to:
| 
