|
System Memory Features
The Desktop Board has two 240-pin DDR2 DIMM connectors with gold-plated contacts. It supports:
- DDR2 800 MHz or DDR2 667 MHz unbuffered, non-registered DIMMs
- Serial Presence Detect (SPD) memory only
- Non-ECC memory
- Memory voltage: 1.8V
- Up to 4 GB of memory
To be fully compliant with all applicable Intel® SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your memory modules do not support SPD, you will see a notification to this effect on the screen at power up. The BIOS will attempt to configure the memory controller for normal operation. Supported Memory Configuration
| DIMM Capacity |
Configuration |
SDRAM Density |
SDRAM Organization Front-side/Back-side |
Number of SDRAM Devices |
| 256 MB |
Single sided |
256 Mbit |
32 M x 8/empty |
8 |
| 256 MB |
Single sided |
512 Mbit |
32 M x 16/empty |
4 |
| 512 MB |
Double sided |
256 Mbit |
32 M x 8/32 M x 8 |
16 |
| 512 MB |
Single sided |
512 Mbit |
64 M x 8/empty |
8 |
| 512 MB |
Single sided |
1 Gbit |
64 M x 16/empty |
4 |
| 1 GB |
Double sided |
512 Mbit |
64 M x 8/64 M x 8 |
16 |
| 1 GB |
Single sided |
1 Gbit |
128 M x 8/empty |
8 |
| 2 GB |
Double sided |
1 Gbit |
128 M x 8/128 M x 8 |
16 | |
This applies to:
| 
