|
|
|
 |
 |
|
| Intel® Desktop Board CA810E |
|
 |
|
|
Contents
Tested Memory
Memory testing has been performed under the following categories:
Basic Self Tested Memory
Intel provides the Basic test procedures and test software to memory
manufacturers to perform testing on their own products. These products
are then listed on the manufacturer's own website. Use the Basic
Self Tested Memory links to visit their sites to obtain information
on their products.
Intel Internal Tested Memory
Intel's has a limited amount of memory tested for the desktop board.
These part numbers may not be readily available throughout the product
life cycle.
System Memory Features
The desktop board has two, dual inline memory module (DIMM) sockets.
Minimum memory size is 32 MB; maximum memory size is 512 MB. The
BIOS automatically detects memory type, size, and speed. Due to
the video requirements of the Intel® Desktop Board CA810E, most configurations
require at least 64 MB of memory.
The desktop board supports the following memory features:
- 168-pin DIMMs with gold-plated contacts
- 100 MHz unbuffered SDRAM
- Non-ECC (64-bit)
- 3.3 V memory only
- 100 MHz memory may be either Serial Presence Detect (SPD) or
non-SPD memory (see caution below about using non-SPD memory)
- Unbuffered Single- or double-sided DIMMs in the following sizes:
| DIMM Size |
Non-ECC Configuration |
| 16 MB |
2 Mbit x 64 |
| 32 MB |
4 Mbit x 64 |
| 64 MB |
8 Mbit x 64 |
| 128 MB |
16 Mbit x 64 |
| 256 MB |
32 Mbit x 64 |
|
Note: 256 MB DIMMs used with this board must be built with
128 Mbit device technology.
Caution: Because the main system memory is also used as video
memory, the Intel Desktop Board CA810E require 100 MHz SDRAM DIMMs. It
is highly recommended that SPD DIMMs be used, since this allows the
BIOS to read the SPD data and program the chipset to accurately configure
memory settings for optimum performance. If non-SPD memory is installed,
the BIOS will attempt to correctly configure the memory settings,
but performance and reliability may be impacted.
All memory components and DIMMs used with the Intel Desktop Board CA810E
must comply with the PC SDRAM Unbuffered DIMM Specification. You
can access this document through the Internet at: http://www.intel.com/technology/memory/index.htm
This applies to:
|
|
|
|
End of Interactive Support AnnouncementThese products are no longer being manufactured by Intel. Additionally, Intel no longer provides interactive support for these products via telephone or e-mail, nor will Intel provide any future software updates to support new operating systems or improve compatibility with third party devices and software products.
THESE DOCUMENTS ARE PROVIDED FOR HISTORICAL REFERENCE PURPOSES ONLY AND ARE SUBJECT TO THE TERMS SET FORTH IN THE "LEGAL INFORMATION" LINK BELOW.For information on currently available Intel products, please see www.intel.com and/or developer.intel.com
|
|
Solution ID: CS-012797
Date Created: 30-Jun-2004
Last Modified: 08-Jun-2006
|
|
