Contents:

• Disclaimer For Communications Application Configurations For Intel® Faxmodems
• Telix 3.20 & 3.15: Compatible With Intel® Modems
• Telix 3.20 & 3.15 Configuration For Intel® Faxmodems
• Telix 3.20 & 3.15 Configuration For Intel® Faxmodems

Intel provides suggested communications application configurations solely as a service to Intel faxmodem customers. Intel assumes no responsibility for errors or omissions in this information. Nor does Intel make any commitment to update this information. If you have questions or problems while configuring a communications application, consult the manual or the manufacturer of the application

This program is compatible with Intel modems. Telix 3.XX uses a program called MODEMCFG.EXE (which is supplied with their software) to provide proper modem configuration information to TELIX. Due to a limitation of the configuration software, DeltaComm Development is not able to add all Intel modems into it's current configuration menu.

To install your Intel modem simply run MODEMCFG.EXE in your Telix directory. You will be presented with a selection of modems from which you should select Intel. If your Intel modem is listed, then highlight the correct entry and allow the program to set your NVRAM. For the following non listed Intel modems choose the selections as indicated below:

Additional Information:
DeltaComm Development
P.O. Box 1185
Cary, NC 27512

FAX # 919-460-4531
Voice # 919-460-4556
BBS # 919-481-9399

Above phone numbers valid as of 2/25/93.

Telix 3.XX uses a program called MODEMCFG.EXE to provide modem configuration information. Due to a limitation of the configuration software, DeltaComm Development is not able to add all Intel Faxmodems into it's current configuration menu. However, you can select the Intel Modem that best matches you Intel Faxmodems capabilities. This configuration information covers these versions of Telix and MODEMCFG.EXE:

TELIX 3.15 With MODEMCFG.EXE 2.02
TELIX 3.20 With MODEMCFG.EXE 3.20

To install TELIX for your Intel Faxmodem, simply run MODEMCFG.EXE in your Telix directory. When you see a selection of modems, choose INTEL then choose the comparable Intel Modem.

Telix is a product of DeltaComm Development.

Above information valid as of 2/25/93.

Telix 3.XX uses a program called MODEMCFG.EXE to provide modem configuration information. Due to a limitation of the configuration software, DeltaComm Development is not able to add all Intel Faxmodems into it's current configuration menu. However, you can select the Intel Modem that best matches you Intel Faxmodems capabilities. This configuration information covers these versions of Telix and MODEMCFG.EXE:

TELIX 3.15 With MODEMCFG.EXE 2.02
TELIX 3.20 With MODEMCFG.EXE 3.20

To install TELIX for your Intel Faxmodem, simply run MODEMCFG.EXE in your Telix directory. When you see a selection of modems, choose INTEL then choose the comparable Intel Modem.

Telix is a product of DeltaComm Development.

Above information valid as of 2/25/93.

This applies to:

Modems and Fax Boards