Products
Intel® Desktop Boards
Hardware Design   Design Components & Products   Intel® Desktop Boards   Desktop Board Products   D925XECV2   Jumper Settings
Intel® Desktop Board D925XECV2
Jumper Settings
Included on this page:
Jumper Block
BIOS Setup Configuration Jumper Settings
Jumper Block

CAUTION
Do not move any jumpers with the power on. Always turn off the power and unplug the power cord from the computer before changing a jumper setting. Otherwise, the board could be damaged.

The figure below shows the location of the jumper block. The 3-pin jumper block determines the BIOS Setup program's mode. The table below describes the jumper settings for the three modes: normal, configure, and recovery. When the jumper is set to configure mode and the computer is powered-up, the BIOS compares the processor version and the microcode version in the BIOS and reports if the two match.

D925XECV2 Jumper Block
BIOS Setup Configuration Jumper Settings
Function/Mode Jumper Setting Configuration
Normal 1-2 The BIOS uses current configuration information and passwords for booting.
Configure 2-3 After the POST runs, Setup runs automatically. The maintenance menu is displayed.
Recovery None The BIOS attempts to recover the BIOS configuration. A recovery diskette is required.

Updated: Monday, November 1, 2004
Back to Top