The browser version you are using is not recommended for this site.
Please consider upgrading to the latest version of your browser by clicking one of the following links.

Support

System Password Reset Procedure for the Intel® Entry Storage System SS4000-E


Last Reviewed: 15-Dec-2016
Article ID: 000006775

Intel® Entry Storage System SS4000-E reset procedure

You can reset the storage system to use its original administrator user name (admin) and password (storage) by pressing the small, recessed reset button on the back of the storage system1.

This also resets the storage system to its original network settings. If you previously configured the storage system to use a specific IP address, it now obtains its IP address from the DHCP server (if any). If you don’t have a DHCP server on the network, it uses its default IP address (192.168.0.101), subnet 255.255.255.0.

The system reset procedure doesn't delete RAID configuration or data on the hard disk drives.

Steps to perform a system reset

  1. With the system powered on.
  2. Depress and hold the reset button on the back of the unit for three to five seconds.

The Intel® Entry Storage System SS4000-E reboots to complete the system reset procedure. The system is inaccessible during this time. When the reboot and reset is complete, you are redirected to the login page indicating the completion of the reset procedure.

Log in using the default user name (admin) and password (storage). You can change the Administrator login from the defaults under the Advanced tab, System selection.

1 For additional information on the system reset button location, see the Intel® Entry Storage System SS4000-E User Guide.

This article applies to: