System memory features
The board has two 204-pin DDR3 SO-DIMM sockets and supports the following memory features:
- DDR3 SDRAM SO-DIMMs with gold-plated contacts
- Unbuffered, single-sided, or double-sided DIMMs
- 4 GB maximum total system memory
- Minimum total system memory: 256 MB
- Non-ECC DIMMs
- Serial presence detect
- DDR3 1066 MHz, DDR3 1333 MHz, DDR3 1600 MHz SO-DIMMs (DDR3 1333 MHz and DDR3 1600 MHz memory will run at 1066 MHz)
Due to passively cooled thermal constraints, system memory must have an operating temperature rating of 85°C. The board is designed to be passively cooled in a properly ventilated chassis. Chassis venting locations are recommended above the system memory area for maximum heat dissipation effectiveness.
To be fully compliant with all applicable DDR3 SDRAM memory specifications, the board should be populated with SO-DIMMs that support the serial presence detect (SPD) data structure. This allows the BIOS to read the SPD data and program the chipset to accurately configure memory settings for optimum performance. If non-SPD memory is installed, performance and reliability may be impacted or the SODIMMs may not function under the determined frequency.
Supported memory configurations
System memory configurations are based on availability and are subject to change.
1Support for one 4 GB SO-DIMM installed in slot 1. Slot 0 must be left empty.
Computer Memory Test Labs* (CMTL) tests third-party memory for compatibility with Intel boards as requested by memory manufacturers. See the CMTL tested memory list* for this Intel® Desktop Board.
The table below lists parts which passed testing during development. These part numbers may not be readily available throughout the product life cycle.
|DDR, DDR2, and DDR3 memory|
|Single and multi-channel memory modes|
|Troubleshooting system memory issues|